Patton-electronic SmartNode 4830 Series Manual de usuario descargar pdf (Pagina 60)

Troubleshooting DSL Connections 60

SmartNode 4830 Getting Started Guide 6 • DSL Basic Configuration

Diagnostics

Troubleshooting DSL Connections

Link State:

• Verify that the DSL link is established (status LED is continuously on)

PPPoE access:

• Check if "show pppoe detail 3" shows "State: .... opened". This indicates that the PVC is valid and a that

you reached a PPPoE server through it.

• Check if "show ppp networks detail 3" shows "State: .... opened" for both the "LCP" and the "CHAP" sec-

tion. If LCP is not working, there is probably no compatible authentication protocol conﬁgured. Make sure

"authentication chap" and "authentication pap" are included in the subscriber setup. If only CHAP failed

there may be an error with the username or password.

• Run the “debug” command: node# debug dsl-setup (See table 15 above).

Table 15. Diagnostics commans

Command Purpose

Step 1 node> show dsl type Displays the type of modem installed.

Step 2 node> show dsl line-state Displays information about the state of the DSL

link.

Step 3 node> show dsl version Display ﬁrmware version information for the

modem.

Step 4 node# debug dsl-setup Lists the conﬁguration interactions between the

gateway and the modem module.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 88 89

Sin comentarios

Patton-electronic SmartNode 4830 Series Manual de usuario Pagina 60