Patton-electronic IM1/I4 Manual de usuario

USERMANUALMODEL IM1/I4Ethernet Bridge withIntegral 4-Port HubQuikConnect™ ModuleSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.pa

1.3 SERVICEAll warranty and nonwarranty repairs must be returned freight pre-paid and insured to Patton Electronics. All returns must have a ReturnM

2.3 TYPICAL APPLICATIONThe Model IM1/I4 QuickConnect™ is designed to plug directlyinto the rear of a Patton Electronics baseband modem (e.g. Model10

3.0 PPP OPERATIONAL BACKGROUNDPPP is a protocol used for multi-plexed transport over a point-to-point link. PPP operates on all full duplex media, and

33..00 CCOONNFFIIGGUURRAATTIIOONNThe Model IM1/14 module plugs into Patton’s fiber and copperbaseband modems to provide Ethernet LAN extension. The

4.1.2 Installing the New QuickConnect™ Module 1) Make sure the power switch on the base unit is off. Leave thepower cord plugged into a grounded ou

4.3 CONNECTION TO THE LINE INTERFACE MEDIAInstructions for connecting the line interface media (twisted pair, orfiber optic cable) are contained with

5.3 LED STATUS MONITORSThe Model IM1/I4 features two LEDs that monitor general operat-ing status and the 10Base-T twisted pair link integrity. Figu

15APPENDIX APATTON MODEL IM1/I4 SPECIFICATIONSLAN Connection: RJ-45, 10Base-T, 802.3 EthernetProtocol: PPP (RFC 1661) with Bridging Control Protocol