Patton-electronic 2155 Manual de usuario

USER MANUAL MODEL 2155 CopperLink Ethernet Extender SALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007 Part# 07M2155Doc# 032111U Rev. ARevise

10 External 48 VDC power supply • Input – Rated voltage: 36–60 VDC – Rated current: 0.25 A DC at nominal 48 VDC – 3-pin locking connector, 3.5 mm pit

11 4.0 OPERATION Once the CopperLink Ethernet Extenders are properly installed, they should operate transparently. No user settings required. This s

12 Table 1: LED status monitor indications LED Description DSL Link (Active Green) Solid green (On) indicates that the end to end DSL Framer Link

13 4.2 TEST MODES The Model 2155 has a built-in proprietary loopback test mode, plus a built-in V.52 BER test pattern generator, for evaluating the

14 APPENDIX A SPECIFICATIONS A.1 GENERAL CHARACTERISTICS • Compact low cost plug-and-play router• 10Base-T Ethernet• Unlimited host support• Six fro

15 A.7 CONNECTORS RJ-45 on line side; shielded RJ-45 on Ethernet port A.8 POWER SUPPLY External 100–240 VAC, 50–60 Hz (universal input option), +5

16 APPENDIX B MODELS 2155 FACTORY REPLACEMENT PARTS AND ACCESSORIES *Only required with optional UI power supply (08055DCUI) Patton Model # Descripti

17 APPENDIX CMODELS 2155 INTERFACE PIN ASSIGNMENTC.1 10BASE-T INTERFACERJ-45• Pin 1: TX+• Pin 2: TX-• Pin 3: RX+• Pin 6: RX-• Pins 4, 5, 7, 8: no co

18Notes_______________________________________________________________________________________________________________________________________________

19Notes_______________________________________________________________________________________________________________________________________________

2 CONTENTS1.0 Warranty Information ... 3 1.1 Radio and TV Interference...

20Notes_______________________________________________________________________________________________________________________________________________

3 1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 2155 components to be free from defects, and will—at our option—repair or replace

4 1.3 SERVICE All warranty and non-warranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have a Retu

5 2.0 GENERAL INFORMATION Thank you purchasing this Patton Electronics product. This product has been thoroughly inspected and tested and is warrant

6 Figure 1. Typical application The 2155/L and 2155/R work together to create a transparent extension between two peered Ethernet LANs. Figure 1 sho

7 3.0 INSTALLATION Because the CopperLink Ethernet Extender requires no configuration, it can be installed quickly. Installation consists of the foll

8 1. To function properly, two Ethernet Extenders must be connected together using twisted-pair, unconditioned, dry, metal wire, between 19 (0.9mm

9 cable. Figure 5 shows how to construct a cable to connect the 10Base-T interface to a 10Base-T Hub. Figure 5. Connecting the 10Base-T interface to